Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
10. Remove the outboard halfshaft boot.
11. NOTE: If grease is contaminated, clean and inspect the joint for wear. Replace the outboard CV joint and shaft assembly if worn or damaged.
Inspect for contaminated grease.
Assembly
1. Pack the outboard CV joint with grease.
1
Use Ford High Temp Constant Velocity Joint Grease E43Z-19590-A or equivalent meeting Ford specification ESP-MIC207-A.
2
Spread any remaining grease from the service kit evenly inside the outboard halfshaft boot.
2. NOTE: Clean the halfshaft boot mounting surfaces of access grease before positioning the halfshaft boot into place.
Position the outboard halfshaft boot and outboard boot clamps.
1
Position the outboard halfshaft boot.
2
Position the boot clamps on the outboard, halfshaft boot.