Ranger 4WD V6-4.0L (2009)
Keyless Entry Transmitter: Testing and Inspection
Remote Keyless Entry (RKE) Transmitter Programming
NOTICE: All Remote Keyless Entry (RKE) transmitters must be programmed at the same time.
1. Before entering the program mode, the vehicle must be electronically unlocked with the RKE transmitter or the door lock control switch while the
driver door is open.
2. Turn the ignition switch from OFF to RUN 8 times within 10 seconds, with the eighth turn ending in RUN. If the module successfully enters
program mode, it locks and then unlocks all the doors.
3. Within 20 seconds, press any button on an RKE transmitter and the doors lock and then unlock to confirm that each RKE transmitter is
programmed. Repeat this step for each RKE transmitter.
4. If the door locks do not respond for any RKE transmitter, wait several seconds and press the button again. If the door locks still fail to respond,
refer to Locks, Latches and Entry Systems See: Body and Frame/Locks/Power Locks/Testing and Inspection. Make sure that no more than the
maximum number (6) of RKE transmitters is being programmed.
5. Exiting the programming mode is accomplished if 1 of the following occurs:
-
The key transitions to the OFF position.
-
20 seconds have passed since entering programming mode or since the last RKE transmitter was programmed.
-
The maximum number of RKE transmitters have been programmed.
