Ranger 4WD V6-4.0L (2009)
7. Install the foam pad and cushion trim cover to the cushion frame and fasten the J-clips.
8. Route the backrest latch release cable through the cushion frame and install the pin-type retainer.
Driver seat
9. Install the seat position sensor and 2 screws to the seat track.
All seats
10. Install the seat track assembly and 4 bolts to the cushion frame.
-
Tighten to 6 Nm (53 lb-in).
Passenger seat
11. Install the seat wiring harness retainer clip and attach the seat wiring harness connector to the seat cushion frame.
All seats
12. Attach the cushion trim cover rear J-clip.
13. Install the backrest assembly. For additional information, refer to Seat Backrest - Front, Bucket and 40 Percent See: Seat Back/Service and
Repair/Removal and Replacement/Seat Backrest - Front, Bucket and 40 Percent.
14. Install the seat. If a passenger seat has been serviced, do not prove out the SRS at this time. For additional information, refer to front seat Seat
- Front See: Service and Repair/Front Seats/Seat - Front.
Passenger seat
15. WARNING: Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield,
etc.) are correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious