Ranger 4WD V6-4.0L (2009)
5. Remove the bolt and position the camshaft sprocket aside.
LH side
6. Remove the LH hydraulic chain tensioner. For additional information, refer to Timing Drive Components - Hydraulic Chain Tensioner, LH See:
Service and Repair/Removal and Replacement/Timing Drive Components - Hydraulic Chain Tensioner, LH.
7. Install the Camshaft Sprocket Holding Tool and the Adapter for 303-564 on the front of the LH camshaft and tighten the 2 top clamp bolts to 10
Nm (89 lb-in).
8. Loosen the bolt.
9. Remove the bolt and position the camshaft sprocket aside.
Both sides
10. NOTE: Mark the position of the camshaft bearing caps so they can be installed in their original positions.
Remove the 8 bolts in the sequence shown on each side and remove the camshaft bearing caps.
