Ranger 4WD V6-4.0L (2009)
4. Remove the heater tube assembly front bolt and use it to install the Engine Lifting Bracket.
-
Tighten to 28 Nm (21 lb-ft).
LH side
5. Remove the 2 LH engine support insulator-to-LH engine bracket nuts.
-
To install, tighten to 110 Nm (81 lb-ft).
RH side
6. Remove the 2 RH engine support insulator-to-RH engine bracket nuts.
-
To install, tighten to 110 Nm (81 lb-ft).
Both sides
7. Install the Engine Support Bar and the 2 Adapters for 303-290A and raise the engine until the engine brackets clear the engine support insulator
studs.
LH side
8. Remove the 3 pushpins and the inner fender splash shield.
9. If equipped, remove the LH front coil spring.
10. NOTE: Some vehicles are equipped with a 2-piece dual converter Y-pipe (LH and RH).
If equipped with a front axle, remove the dual converter Y-pipe.
11. If equipped, secure the axle housing to a suitable jack.
12. NOTICE: Any time bolts, washers, spacers or nuts are loosened in the front axle housing for any reason, install new components to
