Ranger 4WD V6-4.0L (2009)
-------------------------------------------------
B9 CHECK THE 4X4 CONTROL MODULE
-
Disconnect: 4X4 Control Module C281a.
-
Measure the resistance between the SJB C2280c-2, circuit CPL12 (VT/OG), harness side and ground.
-
Is the resistance greater than 10,000 ohms?
Yes
GO to B18.
No
REPAIR the circuit. TEST the system for normal operation.
-------------------------------------------------
B10 CHECK THE RH FRONT DOOR AJAR SWITCH FOR A SHORT TO GROUND
-
Disconnect: RH Front Door Ajar Switch C602.
-
Enter the following diagnostic mode on the scan tool: SJB DataLogger.
-
Monitor the SJB RH front door ajar switch PID (P_DR_SW).
-
Did the door ajar PID change with the switch disconnected?
Yes
INSTALL a new door ajar switch. TEST the system for normal operation.
No
GO to B11.
-------------------------------------------------
B11 CHECK CIRCUIT CPL31 (WH) FOR A SHORT TO GROUND
-
Ignition OFF.
-
Disconnect: SJB C2280d.
-
Measure the resistance between the RH front door ajar switch C602-1, circuit CPL31 (WH), harness side and ground.
-
Is the resistance greater than 10,000 ohms?
Yes
GO to B16.
No
REPAIR the circuit. TEST the system for normal operation.
