ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2012 > < Initial Inspection and Diagnostic Overview|Page 2010
Page 22
background image

-------------------------------------------------
H7 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE SJB DISCONNECTED

-

Disconnect: SJB C2280c.

-

Enter the following diagnostic mode on the scan tool: Network Test.

-

Repeat the network test.

-

Do all modules pass the network test?

Yes

INSTALL the removed fuse. CONNECT the SJB. Go To Pinpoint Test D.  See: Pinpoint Test D: The Smart Junction Box (SJB) Does Not Respond To
The Scan Tool

No

CONNECT the SJB. GO to H8.

-------------------------------------------------
H8 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISABLED

NOTE: When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.

-

Disconnect: SJB Fuses 9 (5A), 10 (10A) and 33 (5A).

-

Enter the following diagnostic mode on the scan tool: Network Test.

-

Repeat the network test.

-

Do all other modules pass the network test?

Yes

INSTALL the removed fuses.

If the vehicle is equipped with a 4X4 control module, GO to H9.

If the vehicle is not equipped with a 4X4 control module, Go To Pinpoint Test E.  See: Pinpoint Test E: The Instrument Cluster (IC) Does Not Respond
To The Scan Tool

No

INSTALL the removed fuses.

If the vehicle is equipped with a 4X4 control module, GO to H10.

If the vehicle is not equipped with a 4X4 control module, GO to H11.

-------------------------------------------------
H9 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISCONNECTED

NOTE: When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.

-

Disconnect: IC C220b.

-

Enter the following diagnostic mode on the scan tool: Network Test.

-

Repeat the network test.

-

Do all other modules pass the network test?

Yes

INSTALL the removed fuses. Go To Pinpoint Test E.  See: Pinpoint Test E: The Instrument Cluster (IC) Does Not Respond To The Scan Tool

No

INSTALL the removed fuses. GO to H10.

-------------------------------------------------

Initial Inspection and Diagnostic Overview|Page 2012 > < Initial Inspection and Diagnostic Overview|Page 2010