Ranger 4WD V6-4.0L (2009)
1. Remove the rear door trim panel.
2. For RH, disconnect the Belt Tension Sensor (BTS) electrical connector.
-
Make sure the ignition is OFF and wait one minute before disconnecting or disturbing the BTS.
-
Disconnect the BTS electrical connector.
-
Release the pin-type retainer and detach the wiring harness.
3. Remove the bolt and safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
4. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible.
To install, reverse the removal procedure.
5. Check the active restraint system for correct operation. For additional information, refer to Safety Belt System See: Testing and Inspection.
