Ranger 4WD V6-4.0L (2009)
Transmission Mount: Service and Repair
5R44E and 5R55E
Transmission Insulator and Retainer
Transmission Insulator and Retainer
Removal
NOTE: Rear Wheel Drive (RWD) procedure shown, Four-Wheel Drive (4WD) similar. The front driveshaft must be removed.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they can be installed in their original alignment.
Mark the rear driveshaft.
3. Remove the 4 rear driveshaft bolts.
4. NOTE: Do not use a hammer.
Remove the rear driveshaft from the flange using a pry bar.