Ranger 4WD V6-4.0L (2009)
9. NOTE: Apply petroleum jelly on the valve body separator plate to hold it in place on the main control valve body.
NOTE: Use a new bonded separator plate.
Install the main control valve body separator plate to the main control valve body.
10. Install the Valve Body Aligners into the main control valve body.
11. Install the valve body separator plate-to-main control valve body screws.
-
Tighten to 7 Nm (62 lb-in).
12. Remove the Valve Body Aligners from the main control valve body.
13. Rotate the main control valve body so the valve body separator plate is facing down.
14. NOTE: All solenoid electrical connectors must face upward on installation.
NOTE: All shift solenoids are interchangeable.
NOTE: If the TCC valve came out during disassembly, use caution when installing the TCC solenoid.
Install the SSB, SSD, TCC and EPC solenoids.