Ranger 4WD V6-4.0L (2009)
Quarter Window Glass: Service and Repair
Window Glass - Rear Quarter
Removal
NOTE: If the rear quarter window glass is being removed to repair a dust/water leak, remove and reinstall the existing rear quarter window glass.
1. Remove the rear door trim panel or C-pillar trim panel.
2. Remove the rear quarter window glass nuts.
3. NOTICE: Use only a plastic windshield setting tool to slide under the seal to separate the foam core butyl from the glass. Once the glass
starts to separate from the body, constant hand pressure will break the seal and the glass can be removed. Failure to use a plastic
windshield setting tool can damage the body or the glass frame.
Remove the rear quarter window glass.
Installation
1. NOTE: Remove as much as possible of the foam core butyl from the body and rear quarter window glass prior to installation.
Install the rear quarter window glass.
-
Apply foam core butyl to the window. Overlap the foam core butyl by 25 mm (1 in) at the bottom middle of the rear quarter window glass.
-
Place glass in body opening.
2. Install the rear quarter window glass nuts.
-
Tighten to 2 Nm (18 lb-in).
-
Test the rear quarter window glass for water leaks.
3. Install the rear door trim panel or C-pillar trim panel.