Removal and Installation Special Tool(s) | 308-554 Remover/Installer, Clutch Master Cylinder | | 308-651 Installer, Clutch Master Cylinder Sensor | Materials Name Specification Grease WSD-M1C230-A Removal NOTE:Removal steps in this procedure may contain installation details. All vehicles | -
Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation). | | -
Refer to: Air Cleaner (303-12A Intake Air Distribution and Filtering - 2.0L Duratec-HE (MI4)/2.3L Duratec-HE (MI4), Removal and Installation). Refer to: Air Cleaner (303-12C Intake Air Distribution and Filtering - 1.8L Duratorq-TDCi (Lynx) Diesel, Removal and Installation). Refer to: Air Cleaner (303-12C Intake Air Distribution and Filtering - 1.8L Duratorq-TDCi (Lynx) Diesel, Removal and Installation). | LHD Vehicles | -
Refer to: Battery (414-01 Battery, Mounting and Cables, Removal and Installation). | Right-hand drive vehicles | -
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | All vehicles | -
Extract brake fluid from the brake fluid reservoir until the level reaches the MIN mark. | Right-hand drive vehicles LHD Vehicles All vehicles | -
CAUTION:Make sure that all openings are sealed. | Installation | -
Coat the clutch master cylinder gaiter with grease before installing. | | -
To install, reverse the removal procedure. | | -
Refer to: Clutch System Bleeding (308-00 Manual Transmission/Transaxle and Clutch - General Information, General Procedures). | | -
Refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures). | |