Removal and Installation Special Tool(s) | Separator, Ball Joint 211-020 (13-006) | Removal | -
CAUTION:Leave the tie-rod end retaining nut in place to protect the ball joint stud. Loosen the tie-rod end locknut and the tie-rod end retaining nut. - Loosen the locknut.
- Remove and discard the cotter pin.
- Loosen the retaining nut.
| | -
CAUTION:Protect the ball joint seal using a soft cloth to prevent damage. Using the special tool, detach the tie-rod end from the wheel knuckle. - Release the tie-rod end.
- Remove and discard the tie-rod end retaining nut.
| | -
NOTE:Make a note of the number of turns used to remove the tie-rod end. Remove the tie-rod end. | Installation | -
NOTE:Install the tie-rod end using the same number of turns used to remove it. Install the tie-rod end. | | -
WARNING:Install a new tie-rod end retaining nut. Failure to follow this instruction may result in personal injury. WARNING:Install a new cotter pin. Failure to follow this instruction may result in personal injury. Attach the tie-rod end to the wheel knuckle. - Tighten the retaining nut.
- Tighten the locknut.
| | |