General Procedures Name Specification Spacer washer set | -
Measurement for recessed pulley Check the air gap A between the drive plate and the pulley at 60 degree intervals around the circumferance of the pulley, while operating the A/C clutch several times by means of a 5A fused jumper wire connected between the battery positive terminal, A/C clutch and battery ground. For additional information, refer to Specifications in this section. - Belt pulley
- Drive plate
- Air gap A (the difference measured between the A/C clutch engaged and disengaged)
| | -
Measurement for non recessed pulley Check the air gap A between the drive plate and the pulley at 60 degrees intervals around the circumference. For additional information, refer to Specifications in this section. - Belt pulley
- Spacer washer
- Drive plate
| | -
Correct air gap A as necessary using spacer washers. | | -
Install the drive plate. For additional information, refer to Specifications in this section. | | -
Check air gap A as described in step 1 or step 2. Repeat steps 3-5 if necessary. | | |