Taurus V6-182 3.0L DOHC SHO (1992)
5.
Reposition and secure cooling fan motor harness to mounting pad located on fan shroud to the right of the original location using existing retainer.
See Figure 1-DD.
6.
Install jumper harness onto fan shroud as shown in Figure 2-DD. Make sure harness is positioned so fuse holder is as far away from retainer as
possible. Refer to Figure 2-DD.
7.
Position fuse holder in place on radiator upper support sheet metal and mark location of the mounting hole. See Figure 2-DD.
CAUTION
The radiator and a wire harness are located directly below the area to be drilled. Position the wire harness out of the way prior to drilling. Use a
drill stop or other device to prevent damage to the radiator.
8.
Position the fuse holder out of the way. Then, using a 9/32 inch drill bit, drill one (1) hole at location marked in Step 7.
NOTE: