Taurus V6-182 3.0L DOHC SHO (1992)
5. Drive out three pinion shaft retaining pins using 5/32 inch drift.
6. Remove final drive ring gear rivets using 3/8 inch drill bit.
CAUTION: Drill only preformed side of rivet to prevent distorting case.
7. Drive out rivet shanks with punch, then use press to remove final drive ring gear from differential case.
8. Separate differential by lightly tapping lefthand side away from righthand side using hammer and drift, then remove left side gear and thrust
washer from case.
9. Using drift and hammer, gently tap long pinion shaft through rear axle pinion shaft seat and pinion gear, then remove shaft from case.
10. Remove four pinion gears, thrust washer, rear axle pinion shaft seat, and righthand side gear and thrust washer.
INSTALLATION
1. Reverse procedure to install, noting the following:
a. Lubricate thrust washers and thrust surfaces on gears and differential case with transaxle fluid.
b. Use only final drive ring gear bolts and nuts supplied for service.
c. Note direction of final drive ring gear bolts.
d. Install speedometer drive gear so tangs are position on upper side of gear. differential
e. Install bearings using differential bearing cone installer tool No. T83P-4220-CH, or equivalent.
