Taurus V6-182 3.0L VIN 1 FI Flex Fuel (1997)
6. Lubricate timing chain, crankshaft sprocket and camshaft sprocket with Engine Assembly Lubricant D9AZ-19579-D or equivalent meeting Ford
specification ESR-M99C80-A and install as a unit.
Fig. 8 Timing Chain Alignment
7. Align marks as illustrated. Inspect camshaft sprocket bolt for blockage of drilled oil passages and clean as required. Install bolt and washer and
tighten to 50-70 Nm (37-51 ft. lbs.).
8. Lubricate valve tappets and bore with Engine Assembly Lubricant D9AZ-19579-D or equivalent meeting Ford specification ESR-M99C80-A.
9. Install valve tappets into original bores.
NOTE: Install plate with the word "UP" and or button visible.
10. Aligning valve tappet flats, install valve tappet guide plate.
11. Install tappet guide plate and retainer over valve tappet guide plate. Hand-start two retaining bolts. Tighten bolts to 10-14 Nm (89-123 inch lbs.).
Surface Preparation
Prior to applying sealer, clean sealing surfaces with Metal Surface Cleaner F4AZ-19A536-RA or equivalent meeting Ford specification
WSE-M5B392-A, to remove all residues that may interfere with the sealer's ability to adhere.
12. Apply a 6 mm (1/4 inch) drop of Silicone Rubber D6AZ-19562-AA or BA or equivalent meeting Ford specifications ESB-M4G92-A and
ESE-M4G195-A to intersection of cylinder block and cylinder head at four corners.
13. Position intake manifold gaskets onto cylinder heads. Align intake manifold gasket locking tabs to the provisions on the head gaskets.
14. Install front and rear intake manifold end seals. Secure with retaining features.