Taurus V6-182 3.0L VIN 1 FI Flex Fuel (1997)
leakage could occur.
2. Lubricate fuel injector O-rings and install two on each fuel injector using clean engine oil meeting Ford specification WSS-M2C153-F.
NOTE: On flexible fuel vehicles, use oil with an API designation of Multi-Fuel Vehicles (MFV).
3. Make sure fuel injector cups are clean and free of contamination or damage.
4. Install fuel injectors in fuel injection supply manifold using light, twisting-pushing motion.
5. Carefully install fuel injection supply manifold and fuel injectors into lower intake manifold, one side at a time. To make sure that fuel injector
O-rings are seated, firmly push down on fuel injection supply manifold.
6. While holding fuel injection supply manifold in place, install retaining bolts and tighten to 8-12 Nm (71-106 lb in).
7. Connect fuel supply and fuel return lines as described.
8. Before connecting the engine control sensor wiring, turn ignition switch to the RUN position several times without starting engine. This will
pressurize the fuel system.
9. Using a clean paper towel and rubber gloves, check for leaks where the fuel injectors connect to the fuel injection supply manifold and intake
manifold. If leaks are detected, service as required.
10. Connect the engine control sensor wiring to the fuel injectors.
11. Install upper intake manifold.
12. Start engine, allow to idle and check for fuel leaks. Service if necessary.
