Taurus V6-182 3.0L VIN 1 FI Flex Fuel (1997)
Tether Attachment Location -- Taurus
2. To help find the correct hole beneath the rear window trim panel for the center tether anchor bracket, find attached to the instruction sheet four
templates. Two of these templates are required. Cut out the template following the instructions on the template.
3. Position the template on the rear window trim panel so that it aligns with the perimeter of the outer edge of the rear seat speaker. Tape the template
down to the trim panel.
4. With the template taped down, use a knife (or the equivalent) to poke through the soft finish material surface of the rear window trim panel in the
dotted lined areas indicated on the template.
WARNING: Use protective eye wear when cutting through the trim panel material.