Taurus V6-182 3.0L VIN 1 FI Flex Fuel (1997)
6.
Remove O-ring seal from servo piston. See Figure 6. Obtain new servo piston O-ring seal. Lubricate new O-ring seal with petroleum jelly and
install it on the servo piston.
7.
Obtain new servo cover, O-ring seal and gasket. Lubricate the inside of the servo cover and the O-ring. Install the O-ring onto the servo cover. Use
petroleum jelly at each corner of the gasket to hold it in place, and install it onto the servo cover. See Figure 7.
8.
Compress the servo piston and spring, and position the servo cover over the servo piston. Align the tab on the servo cover with the port on the
transaxle case.
9.
While holding the servo cover in place, hand start the servo cover retaining bolts. Evenly tighten the retaining bolts two or three turns at a time to
