Taurus V6-183 3.0L VIN U FI (1993)
Accumulator HVAC: Description and Operation
Fig 8 Suction Accumulator/Drier Dome Type
Refrigerant enters the accumulator/drier canister through the inlet tube and the heavier, oil-laden refrigerant falls to the bottom of the canister. A small
diameter oil bleed hole is located in the side of the outlet tube near the bottom of the canister. This bleed hose is covered with a filter screen and allows a
small amount of the heavier liquid refrigerant and oil mixture to re-enter the suction line at a controlled rate. When the heavier liquid refrigerant and oil
mixture enters the compressor suction line, it has a second opportunity to vaporize and circulate through the compressor without causing damage to the
compressor due to refrigerant slugging.
A desiccant bag is mounted inside the suction accumulator/drier canister to absorb any moisture which may be in the refrigerant system.
A fitting located on the top of the canister is used to attach the clutch cycling pressure switch. A long-travel Schrader-type valve stem core is installed in
the fitting opening to prevent refrigerant loss when the clutch cycling pressure switch is removed.
If it is necessary to check the suction accumulator/drier for excessive refrigerant oil, the oil must be poured from the accumulator through the pressure
switch fitting when the Schrader valve stem is removed.
