Taurus V6-195 3.2L DOHC SHO (1994)
Memory Service Codes/TG90 - Perform Drive Cycle Test
DTC 652
Torque Converter Clutch solenoid circuit failure.
KOEO Hard Code ..................................................................................................................................................................................... Go to TC1
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/TC - Transmission Solenoids/TC1 - Enter
Output State Diagnostic Test Mode
DTC 653
Transmission Control Switch did not change states during KOER self-test.
KOER Hard Code ..................................................................................................................................................................................... Go to TB2
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/TB - 4X4 Low/Transmission Control
TCIL-TCS-TCSM/TB2 - Diagnostic Trouble Codes 65, 632 and 653
DTC 654
Transmission Range sensor not indicating "PARK" during KOEO self-test.
KOEO Hard Code .................................................................................................................................................................................... Go to TD1
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/TD - Manual Lever Position (MLP) Sensor
DTC 656
Torque Converter Clutch continuous slip error.
KOEO Memory Code ............................................................................................................................................................................. Go to TG90
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/TG - Electronic Transmission - Continuous
Memory Service Codes/TG90 - Perform Drive Cycle Test
DTC 657
Transmission over temperature condition occurred.
KOEO Memory Code ........................................................................................................................................................................... Go to TE100
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/TE - Transmission Fluid Temperature (TFT)
Sensor/TE100 - Rerun KOEO Self Test
DTC 659
High vehicle speed in park indicated.
KOEO Memory Code ............................................................................................................................................................................. Go to TG90
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/TG - Electronic Transmission - Continuous
Memory Service Codes/TG90 - Perform Drive Cycle Test
DTC 667
Transmission Range sensor circuit voltage below minimum voltage.
KOEO Memory Code ............................................................................................................................................................................. Go to TG90
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/TG - Electronic Transmission - Continuous
Memory Service Codes/TG90 - Perform Drive Cycle Test
DTC 668
Transmission Range circuit voltage above maximum voltage.
KOEO Memory Code ............................................................................................................................................................................. Go to TG90
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/TG - Electronic Transmission - Continuous
Memory Service Codes/TG90 - Perform Drive Cycle Test
DTC 675
Transmission Range sensor circuit voltage out of range. Hard fault present, vehicle is in Failure Mode Effects Management (FMEM).
KOEO Memory Code ............................................................................................................................................................................. Go to TG90
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/TG - Electronic Transmission - Continuous
Memory Service Codes/TG90 - Perform Drive Cycle Test
DTC 676
Go to Transmission and Drivetrain / Testing and Inspection.