Taurus V6-195 3.2L DOHC SHO (1994)
Inner Spacer
7. Insert inner spacer into piston bore.
8. Place snap ring inside of inner spacer.
9. Position spring compressor and screw and crossblock on push rod, and lightly screw tool clockwise to compress spring. Install snap ring.
CAUTION: Snap ring should click into place. Do not overcompress spring.
10. Install new piston seal in groove in caliper housing after lubricating seal with DOT 3 brake fluid.
11. Coat piston and piston dust boot with DOT 3 brake fluid. Install dust boot into piston bore of caliper. Spread dust boot over piston and seat dust
boot in piston groove. Rotate piston clockwise using Rear Caliper Piston Adjuster T87P-2588-A or equivalent until piston is fully seated.
NOTICE: Ensure one slot in piston face is positioned so it will engage with nib on brake pad.