Taurus V6-195 3.2L DOHC SHO (1994)
Coolant: Initial Inspection and Diagnostic Overview
RADIATOR COOLANT LEVEL TEST
WARNING: Never remove the cooling system cap under any conditions while the engine is operating. Failure to follow these instructions
could result in damage to the cooling system or engine and/or personal injury. To avoid having scalding hot coolant or steam blow out of
the cooling system, or reservoir, use extreme care when removing the cap from a hot cooling system or reservoir. Wait until the engine
has cooled, then wrap a thick cloth around the pressure cap and turn it slowly until the pressure begins to release. Step back while the
pressure is released from the cooling system. When certain all the pressure has been released, (still with a cloth) turn and remove cap.
NOTE: A low coolant level in the radiator can cause poor heater and defroster performance. (Any level below the filler neck is considered low.)
If this condition exists, perform the following:
1. With cold engine, remove radiator cap.
2. With 50/50 mixture of specified anti-freeze solutions and water, fill radiator and replace radiator cap. Observe the level of fluid in the radiator
coolant recovery reservoir. Adjust 50/50 mixture of coolant and water to the FULL COLD mark on the radiator coolant recovery reservoir. Install
reservoir cap, if so equipped.
3. START the engine and run until the water thermostat opens.
4. Shut OFF the engine and allow it to cool down. This permits coolant to be drawn into the radiator.
5. Observe the level of coolant in the radiator coolant recovery reservoir. The minimum level should be as specified in Step 2. If not, adjust coolant
level by adding coolant.
6. Check coolant level in radiator when engine has cooled. Radiator should be full. Add coolant if necessary. Repeat Steps 3, 4, and 5.