Taurus V6-195 3.2L DOHC SHO (1994)
2.
Refer to the table for wire color codes and splices to be used.
3.
Strip wires 0.5 inch (7.6 mm), then insert each wire into correct crimp barrel.
4.
Using Crimp Tool (AD-1522), crimp all wires.
5.
Heat splice with heat gun until tubing shrinks and adhesive flows from each end.
6.
Temporarily connect new headlamp switch and install knob.
7.
Connect battery negative cable.
8.
Check operation of headlights, marker lights, tail lights and instrument panel lights.
9.
Disconnect battery negative cable.
10.
Remove headlamp knob and disconnect headlamp switch.