Taurus V6-232 3.8L (1989)
more than 0.08 mm (0.003 in) beyond its original diameter.
8. Wash cylinder with clean denatured alcohol or brake parts cleaner after honing. Dry it with compressed air.
9. Make sure that bleeder hole is open.
ASSEMBLY
NOTICE: Use all parts in the wheel cylinder service kit.
1. Apply light coating of DOT 3 brake fluid to all internal parts.
2. Thread bleeder screw into cylinder.
3. Insert return spring and cup expander assembly, and pistons into their respective positions in cylinder bore. Place a boot over each end of cylinder.
4. Install wheel cylinder.
NOTICE: Ensure that brake line is installed in lower wheel cylinder hole and bleed screw in upper hole. Always perform brake bleeding
procedures before driving vehicle.