Taurus V6-3.0L DOHC VIN S (2000)
9. Using the special tools. disconnect the ball joint from the lower arm.
10. Push the lower arm downward until the ball joint is free of the arm.
11. CAUTION: Use extreme care not to damage boot seal. Do not use power tools to tighten the nut, or bearing and seal damage can result.
Install nut using the hex hold feature to prevent the stud from rotating.
Remove the two nuts and disconnect the front stabilizer bar links.
12. Support the steering gear to prevent damage to the steering shaft.
13. Remove the steering gear nuts.
14. Remove the four bolts holding the power steering line to the frame.