Taurus V6-3.0L DOHC VIN S (2000)
5. Position the driver seat into the vehicle. Connect the ten-pin floor electrical connector to the driver seat.
6. Install the driver seat rear nuts.
7. Install the driver seat rear trim covers.
8. Connect the battery ground cable. For additional information, refer to Battery.
9. With the restraint system diagnostic tools still in place, prove out the air bag system.
10. Position the driver seat to its rearmost position.
11. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to Battery.
12. Install the driver seat front bolts.