Taurus V6-3.0L DOHC VIN S (2000)
1. Position the upholstery to the pad, then install the center hog rings.
2. Position the upholstery, then install the hog rings (seven per side).
3. Install the seat cushion frame.
4. Fasten the J-clips and install the wire harness (if equipped).
5. Install the seat track. For additional information, refer to Seat Track-Manual or Seat Track-Power, Driver Side.
6. Install the seat backrest. For additional information, refer to Front Seat Backrest-Driver Side.
7. Remove the driver safety belt pretensioner restraint system diagnostic tool from the ten-pin floor electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
8. Position the driver seat into the vehicle. Connect the ten-pin floor electrical connector to the driver seat.