Taurus V6-3.0L DOHC VIN S (2000)
2. For bench priming, mount the brake master cylinder in a vise and install short brake tubes with the ends bent into the brake master cylinder
reservoir.
-
Fill the brake master cylinder reservoir with High Performance DOT 3 Brake Fluid C6AZ-19542-AB or DOT 3 equivalent meeting Ford
specification ESA-M6C25-A (United States and Canada only). If DOT 3 is not available, use Ford High Performance DOT 4 Brake Fluid
meeting Ford specification SAEJ1704.
3. Slowly depress the primary piston or, for in-vehicle priming, have an assistant slowly pump the brake pedal until clear brake fluid flows from both
brake tubes with no air bubbles.
4. If necessary, install the brake master cylinder into the vehicle.
5. Remove the short brake tubes and install the master cylinder outlet tubes.
6. Note: Refill the brake master cylinder reservoir as necessary.
Have an assistant depress and hold the brake pedal.
7. Loosen the brake outlet tubes at the master cylinder one at a time.
