Taurus V6-3.0L DOHC VIN S (2000)
8. Pull up and out to release the retaining clips, route the safety belt out and remove the lower B-pillar trim panel.
9. Push in and pull up to release the second row seat cushion and remove the cushion.
10. Remove the trim pad.
1
Remove the retaining screw.
2
Position the seat back downward.
3
Lift to release the retaining clips and pull out to remove the trim pad.
11. If positioned upward, position the third row seat back down.
12. From behind the safety belt guide, release the tabs on each side and carefully pull out and remove the safety belt guide cover.
NOTE: If the safety belt guide cover is damaged or if it does not remain closed, install a new cover.
13. Remove the third row safety belt guide.
1
From behind the quarter trim panel, put a wrench on the second row safety belt guide retaining stud.
2
While holding the hidden fastener, use special tool 501-010 (T77L-2100-A), and remove the bolt.
