Taurus AWD V6-3.5L (2009)
-
Enter the following diagnostic mode on the scan tool: PCM Self-Test.
-
Retrieve the continuous memory DTCs from the PCM.
-
Is DTC P0620, P0625, P0626 or P065B set in the PCM?
Yes
REFER to Charging System.
No
GO to G3.
-------------------------------------------------
G3 CHECK THE BATTERY CONDITION AND STATE OF CHARGE
-
Ignition OFF.
-
Check the battery condition and verify the battery is fully charged. Refer to Battery, Battery Condition Test. See: Starting and
Charging/Battery/Testing and Inspection/Pinpoint Tests
-
Is the battery OK and fully charged?
Yes
GO to G4.
No
REFER to Charging System.
-------------------------------------------------
G4 CHECK THE DSM VOLTAGE SUPPLY
-
Measure and record the voltage at the battery.
-
Disconnect: DSM C341B.
-
Ignition ON.
-
Measure the voltage between the DSM C341B-1, circuit SBP12 (GN/RD), harness side and ground.
-
Is the voltage within 0.2 volt of the recorded battery voltage?
Yes
GO to G5.
No
REPAIR the circuit for high resistance. CLEAR the DTC. REPEAT the self-test.
-------------------------------------------------
G5 CHECK THE DSM GROUND CIRCUIT
-
Ignition OFF.
-
Disconnect: Negative Battery Cable.
-
Measure the resistance between the DSM C341B-24, circuit GD147 (BK/VT), harness side and ground.