Taurus AWD V6-35L (2009) Front Door Window Motor - Glass, Frames and Mechanisms Exploded View
12. Tape the window in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
13. Remove the 11 bolts from the door module.
-
To install, tighten to 8 Nm (71 lb-in).
14. Remove the 3 door latch screws.
-
To install, tighten to 12 Nm (106 lb-in).
15. Disconnect the 6 wiring harness retainers and the 2 connector retainers from the inside of the door module, then feed the wiring harness through
the door module.
16. Remove the front door module. If installing a new door module, transfer parts as necessary.
17. To install, reverse the removal procedure.
-
If installing a new LH front window motor, it must be initialized. For additional information, refer to Window Motor Initialization See:
Windows and Glass/Windows/Service and Repair. If installing the original LH front window motor, it must be de-initialized, then initialized.
For additional information, refer to Window Motor Initialization See: Windows and Glass/Windows/Service and Repair.