Taurus AWD V6-3.5L (2009)
10. Install the pin-type retainer.
11. Raise the window glass and tape it in the full up position.
All vehicles
12. NOTE: Make sure that the interior door handle does not get scratched when it is passed through the rear door module.
Position the rear door module and install the 8 bolts.
-
Tighten to 8 Nm (71 lb-in).
13. Install the 3 rear door latch assembly-to-rear door module bolts.
-
Tighten to 12 Nm (106 lb-in).
14. Install the push button rod on the rear door latch assembly.
15. Connect the rear door latch assembly electrical connector.
16. Position the interior door handle and loosely install the bolt.
17. Untape the window glass, then lower the window glass.
18. Install the window glass clamp bolt.
-
Position the window in the window clamp.
-
Shift the door window glass fully forward.
-
Tighten to 8 Nm (71 lb-in).
19. Install the access hole watershield.
20. Install the rear door trim panel.
21. Center the inside door handle alignment pins to the rear door trim panel and install the interior door handle bolt.
-
Tighten to 7 Nm (62 lb-in).
