Taurus AWD V6-3.5L (2009)
1. For additional information, refer to the procedures.
Seat Backrest - Third Row, Bench
Seat Backrest - Third Row, Bench
Removal and Installation
1. Release the backrest trim cover lower J-strip, open the trim cover and release the inner J-clips.
2. Roll the backrest trim cover up, remove the 4 backrest latch-to-backrest frame bolts and backrest frame.
-
To install, tighten to 50 Nm (37 lb-ft).
3. To install, reverse the removal procedure.
Seat Backrest - Third Row, 50 Percent
Seat Backrest - Third Row, 50 Percent
Removal and Installation
NOTE: To remove the RH 50 percent third row seat backrest, the LH seat inboard trim cover must be removed before the RH seat inboard trim cover
can be removed.
1. Remove the LH seat inboard-outer pivot cover.
2. Release the backrest trim cover lower J-strip, open the trim cover and release the inner J-clips.
3. Remove the pivot bolt.
-
To install, tighten to 23 Nm (17 lb-ft).
4. Roll the backrest trim cover up, remove the 2 backrest latch-to-backrest frame bolts and backrest frame.
-
To install, tighten to 50 Nm (37 lb-ft).
5. To install, reverse the removal procedure.
Seat Backrest - Rear
Seat Backrest - Rear, Taurus, Sable
Removal and Installation
40 Percent Backrest
