Taurus AWD V6-3.5L (2009)
1. Position the backrest latch with cable and install the 4 bolts.
-
Tighten to 25 Nm (18 lb-ft).
2. Attach the backrest latch cable pin-type retainer at the lower left corner.
Seat with manual lumbar
3. Attach the lumbar basket to the backrest frame at the bottom and top.
4. Position the lumbar adjuster and install the 2 screws.
Passenger seat and driver seat with manual lumbar
5. Wrap the 3 tie straps around the backrest latch cable and lumbar cable at the top and sides of the seat backrest frame.
All seats
6. WARNING: Inspect the seat side air bag module cavity in the seat backrest foam pad for any foreign material. If any foreign material is
found, remove it.
Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and increases the risk of serious
personal injury or death in a crash.
WARNING: Before installing the seat side air bag module/deployment chute assembly:
-
Inspect the side air bag module and mounting surfaces for any damage or foreign material.
-
Remove any foreign material from the mounting surfaces of the deployment chute, the seat backrest frame mounting bracket and the
air bag module cavity in the seat backrest foam pad.
-
Install new parts if damaged.
Failure to follow these instructions may result in the seat side air bag deploying incorrectly, which increases the risk of serious personal
injury or death in a crash.
WARNING: If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed,
install a new seat side air bag module. Never try to repair the seat side air bag module. Failure to follow these instructions may result in
the seat side air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
NOTICE: Make sure the side air bag module wiring harness is not pinched between the side air bag module and the backrest frame.
Failure to follow this instruction may result in component damage and/or system failure.
Position the side air bag module studs through the backrest frame and install the nuts.
-
Tighten to 10 Nm (89 lb-in).
7. Route the side air bag module harness down the side of the backrest frame and install the pin-type retainers.
8. Position the backrest foam pad to the backrest frame.
9. NOTE: Vehicle with manual lumbar adjust shown.