Taurus AWD V6-3.5L (2009)
Seat Cushion: Removal and Replacement
Seat Cushion - Rear
Seat Cushion - Rear, Taurus, Sable
Removal and Installation
1. From under the front of the cushion assembly, push each of the 2 seat cushion floor latch release levers to the left of the vehicle. Lift up at the front
and release the front of the cushion assembly.
2. Push the cushion assembly back as far as possible. Lift up at the rear outboard ends of the cushion assembly, clearing the retainer hooks from the
cushion assembly wire, pull the cushion assembly forward and remove it.
3. To install, reverse the removal procedure.
-
Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
Seat Bolster - Rear
Seat Bolster - Rear, Taurus, Sable
Removal and Installation
NOTE: LH shown, RH similar.
