Taurus AWD V6-3.5L (2009)
-
Check the guide pins and boots for binding or damage.
-
Install a new brake caliper anchor plate if it is worn or damaged.
Installation
1. NOTE: To move the piston back into the caliper, the LH piston is turned clockwise and the RH piston is turned counterclockwise.
NOTE: A moderate to heavy force toward the caliper piston must be applied. If sufficient force is not applied, the internal park brake mechanism
clutch cone will not engage and the piston will not compress.
Using the Rear Caliper Piston Adjuster (or equivalent such as OTC tool 7317A), compress the brake caliper piston into its cylinder.
2. Clean the residual adhesive from the brake caliper fingers and pistons using the specified brake parts cleaner.
3. NOTICE: Do not allow grease, oil, brake fluid or other contaminants to contact the brake pad or caliper mating surface or damage to
components may occur. Do not install contaminated pads.
NOTE: Install all the new hardware supplied with brake pad kit.
Install the new spring clips and brake pads.
4. Position the brake caliper and install the 2 bolts.
-
Tighten to 29 Nm (21 lb-ft).
5. If necessary, fill the brake fluid reservoir with clean, specified brake fluid.
6. Install the wheel and tire.
-
Apply brakes several times to verify correct brake operation.
