Taurus AWD V6-3.5L (2009)
2. Remove the battery tray.
3. Remove the air cleaner assembly.
4. Use a suitable suction device to drain the brake master cylinder reservoir.
5. Disconnect the master cylinder brake fluid level indicator switch electrical connector.
6. Disconnect the brake tubes from the master cylinder.
-
To install, tighten to 17 Nm (150 lb-in) on vehicles with ABS.
-
To install, tighten to 22 Nm (16 lb-ft) on vehicles with ABS/stability assist and traction control.
-
Cap the brake tubes and plug the master cylinder ports.
7. NOTE: Make sure that the master cylinder-to-booster seal is removed with the master cylinder.
Remove and discard the 2 brake master cylinder nuts and remove the brake master cylinder.
-
To install, tighten the new nuts to 20 Nm (177 lb-in).
8. To install, reverse the removal procedure.
-
Bleed the brake system.