Taurus AWD V6-3.5L (2009)
3. Remove the crankshaft sensor ring.
4. NOTE: Install the engine stand bolts into the cylinder block only. Do not install the bolts into the oil pan.
Mount the engine on a suitable engine stand.
5. If equipped, remove the heat shield and disconnect the block heater electrical connector.
-
Detach all of the engine block heater harness retainers and remove the harness.
6. Disconnect the PCV hose from the PCV valve.
7. Disconnect the Throttle Body (TB) electrical connector.
8. Detach the wiring harness retainers from the upper intake manifold.