Taurus AWD V6-3.5L (2009)
Installation
1. NOTE: Lubricate the seal lips and bore with clean engine oil prior to installation.
Position the Rear Main Seal Installer onto the end of the crankshaft and slide a new crankshaft rear seal onto the tool.
2. Using the Rear Main Seal Installer and Handle, install the new crankshaft rear seal.
3. Install the crankshaft sensor ring.
4. Install the flexplate. For additional information, refer to Flexplate See: Transmission and Drivetrain/Flex Plate/Service and Repair/Removal and
Replacement/Flexplate.