Taurus AWD V6-3.5L (2009)
7. Detach the 2 clips on each radiator bracket from the radiator support and position the radiator rearward.
8. Remove the 2 radiator brackets.
9. Remove the 2 condenser fitting nuts and disconnect the fittings.
-
Discard the O-ring seals and gasket seals.
-
To install, tighten to 15 Nm (133 lb-in).
10. Release the 2 transmission cooler line clamps and disconnect the lines from the condenser core.
11. Remove the 2 A/C condenser bolts.
-
To install, tighten to 6 Nm (53 lb-in).
12. Lift upward and detach the condenser core from the radiator.
13. Remove the condenser core.
14. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Add the correct amount of clean PAG oil to the refrigerant system.
15. Evacuate, leak test and charge the refrigerant system.
16. Fill the transmission fluid to the correct level.
