ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2696 > < Initial Inspection and Diagnostic Overview|Page 2694
Page 24
background image

Yes

GO to J2.

No

VERIFY the Battery Junction Box (BJB) fuse 32 (30A) or the SJB fuse 12 (7.5) are OK. If OK, REPAIR the circuit in question.
If not OK, Refer to the Wiring Diagrams to identify the possible causes of the short circuit. CLEAR the DTCs. REPEAT the network test with the scan
tool.

-------------------------------------------------
J2 CHECK THE DSM GROUND CIRCUIT FOR AN OPEN

-

Measure the resistance between the DSM C341a-2, circuit GD147 (BK/VT), harness side and ground.

-

Measure the resistance between the DSM C341b-24, circuit GD147 (BK/VT), harness side and ground.

-

Are the resistances less than 5 ohms?

Yes

GO to J3.

No

REPAIR the circuit in question. CLEAR the DTCs. REPEAT the network test with the scan tool.

-------------------------------------------------
J3 CHECK THE MS-CAN CIRCUITS BETWEEN THE DSM AND THE DATA LINK CONNECTOR (DLC) FOR AN OPEN

-

Ignition OFF.

-

Disconnect: DSM C341d.

-

Measure the resistance between the DSM C341d-10, circuit VDB06 (GY/OG), harness side and the DLC C251-3, circuit VDB06 (GY/OG),
harness side.

-

Measure the resistance between the DSM C341d-9, circuit VDB07 (VT/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG),
harness side.

Initial Inspection and Diagnostic Overview|Page 2696 > < Initial Inspection and Diagnostic Overview|Page 2694