ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2715 > < Initial Inspection and Diagnostic Overview|Page 2713
Page 43
background image

-

Disconnect: Battery Junction Box (BJB) Fuses 23 (10A), 47 (15A) and 39 (10A).

-

Enter the following diagnostic mode on the scan tool: Network Test.

-

Repeat the network test.

-

Do all other modules pass the network test?

Yes

INSTALL the removed fuses. Go To Pinpoint Test A.  See: Pinpoint Test A: The PCM Does Not Respond To The Scan Tool

No

INSTALL the removed fuses. GO to R6.

-------------------------------------------------
R6 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE ABS MODULE DISABLED

NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.

-

Disconnect: Battery Junction Box (BJB) Fuse 38 (10A).

-

Enter the following diagnostic mode on the scan tool: Network Test.

-

Repeat the network test.

-

Do all other modules pass the network test?

Yes

INSTALL the removed fuse. Go To Pinpoint Test B.  See: Pinpoint Test B: The ABS Module Does Not Respond To The Scan Tool

No

INSTALL the removed fuse. GO to R7.

-------------------------------------------------
R7 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE STEERING EFFORT CONTROL MODULE (SECM)
DISABLED

NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.

-

Disconnect: SJB Fuses 13 (5A) and 35 (10A).

-

Enter the following diagnostic mode on the scan tool: Network Test.

-

Repeat the network test.

-

Do all other modules pass the network test?

Yes

INSTALL the removed fuses. Go To Pinpoint Test G.  See: Pinpoint Test G: The Steering Effort Control Module (SECM) Does Not Respond To The
Scan Tool

No

INSTALL the removed fuses. GO to R8.

-------------------------------------------------
R8 VERIFY VEHICLE EQUIPMENT - 4X4 CONTROL MODULE

NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.

-

Inspect the vehicle for 4X4.

-

Is the vehicle equipped with 4X4?

Yes

GO to R9.

Initial Inspection and Diagnostic Overview|Page 2715 > < Initial Inspection and Diagnostic Overview|Page 2713