Taurus AWD V6-3.5L (2009)
1. Remove the RDU.
2. NOTE:
-
Make sure the Rear Drive Unit (RDU) Bushing Remover/Installers are positioned with the larger opening toward the bushing to act as the
receiver cup.
-
Make sure the arrow on the Rear Drive Unit (RDU) Bushing Remover/Installers is pointed toward the rear subframe when removing the
bushing.
Assemble the Rear Drive Unit (RDU) Bushing Remover/Installer to the rear subframe and press out the bushing.
Installation
NOTE: There are 2 RDU front bushings in the subframe, this procedure shows how to install one bushing. The procedure for the remaining RDU
bushing is identical.
1. NOTE: Make sure the alignment marks on the Rear Drive Unit (RDU) Bushing Remover/Installers are aligned with the anti-rotation tabs on the
RDU bushing.
Install the RDU bushing into the Rear Drive Unit (RDU) Bushing Remover/Installer.
2. NOTE: Make sure the alignment marks are properly aligned on the Rear Drive Unit (RDU) Bushing Remover/Installer and the anti-rotation tabs
are properly seated in the Rear Drive Unit (RDU) Bushing Remover/Installer.
Install the Rear Drive Unit (RDU) Bushing Remover/Installer onto the RDU bushing.