Taurus AWD V6-3.5L (2009)
2. Install the TSS sensor in the cover and install the bolt.
-
Tighten to 12 Nm (106 lb-in).
3. NOTE: If cleaning the main control assembly or inspecting the valves, refer to Identification Tags. If installing a new main control assembly,
continue with this procedure. See: Application and ID
NOTE: Make sure that the manual pin (part of the TR sensor) is correctly installed in the manual valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body.
4. Inspect the manual pin to make sure it is correctly installed in the manual valve. If not, pull the valve body off the transaxle case. Correctly install
the manual pin in the manual valve and position the valve body in place.
5. Install the TR sensor detent spring and the 10 bolts. Tighten the bolts in the sequence shown.