Taurus AWD V6-3.5L (2009)
13. Position the transmission fluid cooler thermal bypass valve and transmission fluid cooler tube assembly in place and install the 2 nuts.
-
Tighten to 9 Nm (80 lb-in).
14. Connect the transaxle electrical connector and install the wiring harness fastener on the main control cover stud.
15. NOTICE: Make sure that when installing the manual control lever it is fully seated onto the manual control lever shaft or damage to the
manual control lever shaft will occur and the lever will come loose.
NOTICE: Make sure to hold the manual control lever while tightening the manual control lever nut or damage to the manual control
lever and park components will occur.
Install the manual control lever and the nut.
-
Tighten to 18 Nm (159 lb-in).