Taurus AWD V6-3.5L (2009)
Front Door Window Motor: Service and Repair
Window Regulator Motor
Window Regulator Motor
Removal and Installation
NOTE: If installing a new LH front window motor, it must be initialized. Once initialized, obstacle detection and one-touch up mode will be enabled.
NOTE: The LH front window motor must be de-initialized, then initialized whenever the LH front window motor is removed from the window regulator
drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or
lubricants are applied to the window regulator or glass run.
1. Remove the door trim panel and water shield.
2. NOTE: Front door shown, rear door similar.
Disconnect the window motor electrical connector.
3. Secure the glass in position with tape.
4. NOTE: Front door shown, rear door similar.
Remove the 3 window motor screws.
5. Remove the window motor.
6. To install, reverse the removal procedure.
-
If installing a new LH front window motor, it must be initialized. For additional information, refer to Window Motor Initialization See:
Service and Repair. If installing the original LH front window motor, it must be de-initialized, then initialized. For additional information, refer
to Window Motor Initialization See: Service and Repair.