Taurus X AWD V6-3.5L (2009)
-
Apply the urethane adhesive to the top and sides of the windshield from the interior of the vehicle.
-
Apply the urethane adhesive to the bottom of the windshield from the exterior of the vehicle.
11. NOTICE: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks to make sure of correct
adhesion.
After the urethane adhesive has cured, check the windshield seal for air or water leaks through the urethane adhesive bead and add urethane
adhesive as necessary.
12. Position the front headliner.
13. Install the LH and RH assist handles.
14. If equipped, install the overhead console.
15. Install the LH and RH sun visors.
16. Install the LH and RH A-pillar trim panels.
17. Install the LH and RH weatherstrips.
18. Install the cowl panel grille.
19. Clean the interior and exterior windshield glass with glass cleaner.
