Taurus X FWD V6-3.5L (2008)
Taurus X Rear Seat Cushion, Second Row, 60 Percent (Part 2)
Removal and Installation
1. Remove the affected second row seat.
2. NOTE: It is not necessary to remove the hog rings or separate the cushion trim cover and cushion foam pad.
Remove the cushion trim cover and cushion foam pad.
-
Disconnect the cushion heater mat electrical connector and release the pin-type retainer.
3. Remove the screw and recliner handle.
4. Remove the outer recliner trim cover from the outboard side.
-
Remove the screw.
-
Release the retainer tabs and separate the trim covers.
-
Route the pull strap through the hole in the trim cover.
5. Disconnect the power-fold seat motor cable from the recliner.
-
Disconnect the cable jacket from the cable clamp.
-
Rotate the cable end guide to release.